ADTRAN Total Access 600R System Manual page 120

Section 4 User Interface Guide
IP Routing
After completing the DS0 mapping, there are three remaining steps required for the unit to be used for IP
Routing: (1) Ethernet Interface Configuration, (2) T1 Interface Configuration, and (3) Default Gateway
Configuration. All of these procedures are described in the pages that follow.
Router Ethernet Interface Setup
Step
From the Main menu, select R
1
then select ETH [1] S
Press Enter on the P
2
configuration.
3 Set the IP A
4 Set the S
RIP on the Ethernet is disabled by default. If RIP needs to be enabled, press
5
Enter on RIP [+].
6 Press E
Press the down arrow and select the appropriate RIP
7
V2
SECRET
Press the left arrow key to return to the Ethernet menu showing P
8
S
ECONDARY
If the unit needs additional secondary IP addresses, press Enter on
S
ECONDARY
9
Enter each additional secondary IP address and subnet mask. Press "I" to
insert additional entries.
120
Router Ethernet Interface Setup Instructions
OUTER
and press E
ETUP
IP [+] option to enter primary Ethernet
RIMARY
of the Ethernet port.
DDRESS
M of the Ethernet port.
UBNET ASK
on V and select V1 or V2 to activate RIP.
NTER ERSION
(where applicable).
IP .
S
IP [+].The unit supports up to 5 additional LAN segments.
S
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
Action
, select C , select I
ONFIG
.
NTER
METHOD
and
NTERFACES
, , and
DIRECTION
IP and
RIMARY
61200600L1-1A