System Config > Syslog - ADTRAN Total Access 600R System Manual

Section 4 User Interface Guide
S C > M
YSTEM ONFIG
When set to , SNMP gets/sets received over the FDL link are always accepted regardless of the
O
N
community table. When set to
SNMP traffic is rejected if a match is not found. Default is
S C > S
YSTEM ONFIG
Configure the unit Syslog client for use with a Syslog server (supplied with ADTRAN Utilities or available
on most Unix platforms) from this menu.
For additional information, reference RFC3164: The BSD Syslog Protocol.
S C > S
YSTEM ONFIG
IP address of the syslog daemon to which log message should be sent. The values must be dotted decimal
notation.
S C > S
YSTEM ONFIG
The is the format of log messages. "
S
YSLOG FORMAT
Utilities and forces the Syslog Facility to LOCAL0.
configured facility level.
Adtran Utilities may malfunction if messages are received in the Unix format.
S C > S
YSTEM ONFIG
The choices are:
L
OCAL
is the facility level for all messages forwarded from the unit to the syslog server. This allows all messages
received from the IAD to be filtered by facility level. See RFC3164: The BSD Syslog Protocol.
This does not have to correspond to the facility level shown in the terminal mode option.
See SYSLOG using Terminal Mode on page 53.
52
> FDL M
ANAGEMENT
the community table is searched for valid manager IP addresses and the
O ,
FF
YSLOG
> S IP
YSLOG YSLOG
> S F
YSLOG YSLOG
> S F
YSLOG YSLOG
, , ,
0 L 1 L 2 L
OCAL OCAL OCAL
© 2002 ADTRAN, Inc.
> A
ANAGEMENT CCEPT
.
O
N
ORMAT
" uses a format that is compatible with Adtran
A
DTRAN
uses the traditional Unix format and reports at the
U
NIX
ACILITY
, ,
3 L 4 L 5
OCAL OCAL
Total Access 600R System Manual
A SNMP
LL
, , .
L 6 L 7 S
OCAL OCAL YSLOG
F
ACILITY
61200600L1-1A