Reviewing The Rear Panel Design; Rear Panel Interfaces And Leds; Figure 2. Netvanta 4305 Rear Panel Layout - ADTRAN NetVanta 4305 Hardware Installation Manual

NetVanta 4305 Hardware Installation Guide

Reviewing the Rear Panel Design

Figure 2 shows the rear panel for the NetVanta 4305. The chassis is shown with the T1/FT1+DSX-1 NIM
installed.
CONSOLE

Rear Panel Interfaces and LEDs

10/100BaseT Ethernet Interface and Activity LEDs
The Ethernet ports (
flashes when data traffic is being sent or received on the Ethernet port. The green link LED is on when
the router has a good connection to the LAN. See Table A-1 on page 45 for the Ethernet port pinout.
The Ethernet port provides the following:
• 10BaseT or 100BaseT with a single connector
• Auto-negotiation
• CSMA/CD
• IEEE 802.3 compatibility
Console Interface
The interface is an EIA-232 serial port (DCE) which provides for local management and
CONSOLE
configuration (via a DB-9 female connector). Table A-2 on page 45 shows the
Connection directly to an external modem requires a cross-over cable.
NET/DBU Card Slots
The
SLOT 1 NET/DBU
card options are described in the section Option Modules on page 26.
Power Supply
The NetVanta 4305 has a worldwide auto-ranging AC power supply with an IEC connector. The
appropriate 3-prong cable is included in the shipment. Please refer to Supplying Power to the Unit on
page 40 for connection details.
61200890L1-34B
SLOT 3 WIDE MODULE

Figure 2. NetVanta 4305 Rear Panel Layout

) are RJ-48C connectors with LEDs. The yellow activity LED
ETH 0/1, ETH 0/2
and
SLOT 2 NET/DBU
© 2004 ADTRAN, Inc.
WAN-T1 DSX-1 DBU
WAN-T1 DSX-1 DBU
SLOT 2 NET/DBU
card slots support various NIM plug-in cards. These
Physical Description
ETH 0/2
100-250VAC
WAN-T1 DSX-1 DBU
SLOT 1 NET/DBU
ETH 0/1
port pinouts.
CONSOLE
50/60Hz
25