ADTRAN Total Access 600R System Manual page 86

Section 4 User Interface Guide
R > C > I
OUTER ONFIG
Configure the T1 interface parameters from this menu.
The 0 in T1[0] represents a physical port. The T1 physical port will always be 0.
The T1 interface will not appear in the
P
ROTOCOL MODE
entered in the
when the
R > C > I
OUTER ONFIG
The T1 sub-interface is PPP [0.0] if the L2 Protocol is set for
logical ports, respectively. This is a read-only field.
The T1 sub-interface is FRE [0.X] if the L2 Protocol is set for
physical and logical ports, respectively. The T1 physical port is always 0. The X represents the Frame
Relay logical port and will be a number between 0-9 corresponding to the interface number under
>
L2 P C
ROTOCOL ONFIG
R > C > I
OUTER ONFIG
Configure the addressing, address mode, MTU, NAT, and RIP parameters from this menu.
A
CTIVE
This option allows this DLCI to be assumed as active (set to
packets. If set to
N
devices on the network. This can be set to
Default is set to
Y
ES
DLCI
(This option is only available when the
number associated with the virtual circuit on the T1 interface. This number corresponds to the DLCI
number in the
L2 P
86
(T1[0])
NTERFACES
is set for
B
RIDGE
table (
DLCI M
APPING
is set to Frame Relay (
L2 P
ROTOCOL
(T1[0])> S
NTERFACES
> . This is a read-only field.
DLCI M
APPING
(T1[0]) > S
NTERFACES
, the interface will not be put in the route table and will not be seen by other
O
.
L2 P
> C > DLCI M
ROTOCOL ONFIG
© 2002 ADTRAN, Inc.
R > C
OUTER ONFIG
. The T1 interface will not appear if a DLCI is not
A
LL
L2 P (T1[0]-FRE) > C
ROTOCOL
).
FRE
-I
UB NTERFACE
. The [0.0] represents the T1 physical and
PPP
F R
RAME
-
ET UP
) and begin transmitting data
Y
ES
if waiting on future turnup from Frame Relay provider.
N
O
is set to
F
ROTOCOL RAME
table.
APPING
Total Access 600R System Manual
table if the
> I
NTERFACES
> DLCI M
ONFIG
. The [0.X] represents the T1
ELAY
.) This DLCI is the
R
ELAY
61200600L1-1A
L2
)
APPING