L2 Protocol; L2 Protocol (T1[0]) - ADTRAN Total Access 600R System Manual

Total Access 600R System Manual
I (ETH[1]) > S
NTERFACES
Displays the data rate present on the Ethernet interface. The possibilities are
. indicates the
N/A N/A A
read-only field.
I (ETH[1]) > S
NTERFACES
Displays the duplex type present on the Ethernet interface. The possibilities are
. This is a read-only field.
D
UPLEX
L2 P
ROTOCOL
Use the L2 Protocol menu to select the L2 Protocol, configure the protocol specific parameters, and view
the status as shown in Figure 7.
L2 P (T1[0])
ROTOCOL
Configure the L2 Protocol and view the status parameters from this menu.
The 0 in T1[0] represents a physical port. The T1 physical port is always 0.
61200600L1-1A
> D
TATUS ATA
is set to
UTONEGOTIATION
> D
TATUS UPLEX
Figure 7. L2 Protocol Menu
© 2002 ADTRAN, Inc.
R
ATE
and there is no Ethernet connection. This is a
O
N
T
YPE
Section 4 User Interface Guide
, , and
10B T 100B T
ASE ASE
and
F D
ULL UPLEX
H
ALF
69