ADTRAN Total Access 600R System Manual page 53

Total Access 600R System Manual
The remaining Syslog parameters have the following level choices:
FATAL (Highest priority)
ALERT
CRITICAL
ERROR
WARNING
NOTICE
INFO
DEBUG (Lowest priority)
Every log message generated by the IAD has a reporting level priority. If the message priority is lower than
the configured priority for the destination log, the message is not forwarded to the syslog daemon. See
RFC3164: The BSD Syslog Protocol. The lower the log level, the more messages that will be generated.
Setting reporting levels to DEBUG may negatively affect the performance of the IAD, including causing
the IAD to reset.
ADTRAN recommends using DEBUG for only short periods of time for debug purposes
only.
SYSLOG using Terminal Mode
Another option for configuring syslog is using the terminal mode command log dump <logname>. The
logname must be all CAPS and be one of the following names:
FATAL
ALERT
CRITICAL
ERROR
WARNING
NOTICE
INFO
DEBUG
The command will dump all messages for the indicated log (
the internal log buffer to the command line display.
S C > S
YSTEM ONFIG
This entry allows setting the default reporting level for all log entries. If
the individual log entry level,
S C > S
YSTEM ONFIG
Minimum required level for sending KERNEL log messages.
61200600L1-1A
> ALL L
YSLOG EVEL
overrides the individual log reporting level.
ALL L
EVEL
> KERNEL L
YSLOG
© 2002 ADTRAN, Inc.
ALL L
EVEL
EVEL
Section 4 User Interface Guide
shows all log messages) stored in
is a lower priority than
ALL L
EVEL
53