ADTRAN Total Access 600R System Manual page 50

Section 4 User Interface Guide
S C > M
YSTEM ONFIG
Activate the SNMP management and configure the SNMP communities and traps from this menu.
S C > M
YSTEM ONFIG
When set to , SNMP access is denied. When set to
O
FF
on the configuration. The factory default is
S C > M
YSTEM ONFIG
Set up the SNMP communities parameters from this menu.
#
Displays the index number of the SNMP Communities.
This list is used to set up to eight SNMP communities that the unit will allow.
N
AME
This is the text string used to identify the SNMP community. The factory default is no entry in the
name parameter.
P
RIVILEGE
The access for this manager can be assigned three levels. The factory default is
N
ONE
G
ET
G /S
ET ET
M IP
ANAGER
This may be used in conjunction with the Netmask field to define a range of manager IPs. A netmask
of 255.255.255.255 defines a single IP as the manager host IP. The default value is
N
ETMASK
The mask is used to determine which bits of the
care." A "1" bit means that the corresponding address bits in the incoming SNMP packet must match
the address bit in the defined
the manager host IP. The default value is
50
> SNMP M
ANAGEMENT
> SNMP M
ANAGEMENT
.
O
N
> SNMP M
ANAGEMENT
No access is allowed for this community or manager.
Manager can only read items.
Manager can read and set items.
. The netmask of 255.255.255.255 defines a single IP as
M IP
ANAGER
0.0.0.0
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
ANAGEMENT
> A
ANAGEMENT CCESS
, the unit will respond to SNMP managers based
O
N
> C
ANAGEMENT OMMUNITIES
are significant. A "0" bit means "don't
M IP
ANAGER
.
.
GET
.
0.0.0.0
61200600L1-1A