ADTRAN Total Access 600R System Manual page 140

Section 5 DLP-004
Perform Steps Below in the Order Listed
1. Connect the unit to your VT100 system (details found in DLP-001, Connecting the Terminal or PC to
the CRAFT Port).
2. Log in to the system with maximum rights (details for logging in are in DLP-002 and
DLP-003).
3. From the R /C
OUTER
4. Select the P
RIMARY
Enter the appropriate IP address.
5. From the R /C
OUTER
option and press <Enter>.
Enter the appropriate Subnet Mask.
6. From the R /C
OUTER
Enter the appropriate Default Gateway.
7. Escape out to the R
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
140
DLP-004
/I (E
ONFIG NTERFACES TH
IP option and press <Enter>. Select IP A
/I (E
ONFIG NTERFACES TH
/R menu, select the D
ONFIG OUTES
menu and log off by pressing <Ctrl + L>.
OUTER
© 2002 ADTRAN, Inc.
[1]) menu, select the S
ETUP
DDRESS
[1])/S /P IP menu, select the S
ETUP RIMARY
G
EFAULT ATEWAY
Total Access 600R System Manual
option and press <Enter>.
and press <Enter>.
UBNET
option and press <Enter>.
61200600L1-1A
M
ASK