ADTRAN Total Access 600R System Manual page 87

Total Access 600R System Manual
A M
DDRESS ODE
This option determines how the WAN interface receives its IP address.
mode of operation.
• The choices are
.
PPP
• The choices are
to
F R
RAME
• If using the Auto-config option and the
This means the unit will learn its IP address from a router on the WAN during IPCP
negotiation. It is the same mechanism used by the auto-detection algorithm.
• If using the Auto-config option and the
. This means a DHCP Server from the service provider will issue this unit an IP address
C
LIENT
using DHCP.
• If the Auto-config option is not used, the
allows the IP addresses to be statically programed into the unit.
R
ELAY
L IP A
OCAL DDRESS
(This option is only applicable in
WAN IP address and can be statically assigned if using numbered interfaces. For
is the numbered IP associated with this DLCI interface. This address is used by the unit to respond to
Inverse ARP requests. If this IP address is left as
unit responds to the Inverse ARP with its Ethernet IP address. Default is
IP N
ETMASK
(This option is not available for
IP netmask which is applied to the
Default is
0.0.0.0.
determining the PPP peer's network. If left as
0.0.0.0.
F -E IP A
AR ND DDRESS
(This option is not available for
, or
A M
DDRESS ODE
the device on the other end of the virtual circuit. When this DLCI becomes active, the unit will add a
route in the IP routing table. Default is
network can be set here, if known. Leaving this at
peer's IP and network (if unnumbered) using the PPP IPCP. Default is
61200600L1-1A
(default) and
U S
SER PECIFIED
(default),
U S
SER PECIFIED
. can be used to learn the far-end IP address.
IARP
ELAY
U S
SER PECIFIED
F R
RAME ELAY
F -E
AR ND
For the PPP protocol, this network mask is applied to the
F R
RAME ELAY
PPP IPCP A A
SSIGNED
0.0.0.0.
© 2002 ADTRAN, Inc.
IPCP A
SSIGNED
, and
IARP DHCP C
is
L2 P PPP
ROTOCOL
is
L2 P F
ROTOCOL
U S
SER PECIFIED
address mode.) For
, the link is treated as unnumbered and the
0.0.0.0
DHCP C A
LIENT DDRESS
and
IP A L
DDRESS OCAL
, a standard network mask is used. Default is
0.0.0.0
DHCP C A
LIENT DDRESS
For Frame Relay, this is the IP address of
M .)
DDRESS ODE
For the PPP protocol, the PPP peer's IP address or
means that the unit will determine the PPP
0.0.0.0
Section 4 User Interface Guide
is the normal
U S
SER PECIFIED
if the
L2 P
ROTOCOL
if the
L2 P
LIENT ROTOCOL
, the default is
IPCP A
, the default is
R
RAME ELAY
option for both and
PPP
, this IP address is the local
PPP
F R
RAME
0.0.0.0.
.) For Frame Relay, the
M
ODE
is specified here.
IP A
DDRESS
F -E IP
AR ND ADDRESS
M , F R
ODE RAME ELAY
0.0.0.0.
is set to
is set
.
SSIGNED
DHCP
F
RAME
, this
ELAY
for
IARP
87