ADTRAN Total Access 600R System Manual page 121

Total Access 600R System Manual
Router T1 Interface Setup
Before configuring the Router T1 Interface, choose
instructions for the
PPP
to , reference DLP-014, Unit Installation Using The Auto-Config Feature.
P A
ROTOCOL UTO
Router T1 Interface Setup Instructions when L2 Protocol = PPP
Step
1 From the Main menu, select L2 P
2 Set the T1 [0] interface protocol to PPP.
3 Press Enter on the C
Press Enter on the A
related to how the link is established. Default is T
4
M
ETHOD
than N
5 Left arrow back to the Main menu.
Select router, select C
WAN information:
• Far-End IP Address
6
• IP Netmask
• Local IP Address
The other config items can be left at the defaults.
For NAT configuration, please see the IP Routing with NAT section of this
7
appendix. On page 123.
61200600L1-1A
and are described on the following pages. For information on setting the
FRE
[+] option. Verify mode is R
ONFIG
UTHENTICATION
= N . If TX M
ONE ETHOD
, TX/RX
ONE USERNAME
, select I
ONFIG
The far-end WAN IP address from the unit.
The subnet mask for this WAN link
The local WAN IP address for the unit.
© 2002 ADTRAN, Inc.
and select
L2 P
ROTOCOL
Action
and press E
ROTOCOL
[+] option if you wish to change options
M
X ETHOD
and RX M are set to any option other
ETHOD
and P options will appear.
ASSWORD
, and select T1 [0]
NTERFACES
Section 4 User Interface Guide
, , or . Setup
PPP FRE A
UTO
.
NTER
IP.
OUTE
= N and RX
ONE
. Enter
SETUP
L2
121