Goldacres Crop Cruiser G6 Operator's Manual page 27

Air Conditioning
Activating ECON Mode
In ECON mode, the air conditioner compressor
is shut down. The heater and – depending on the
setting – the ventilation are controlled automatically.
• Use this mode when cooling is not required
Activating the ECON mode
• Press button (9)
Indicator light (9) lights up. Indicator light (2) goes
out. The ECON mode is active.
Drying Cab Windows
For drying the cab windows, the compressor is on
constantly at maximum fan speed. The heater is set
to the pre-set set value.
Drying the cab windows:
• Press button (3)
Indicator light (3) lights up. The drying mode is active.
The fan is set to maximum speed.
To change the fan speed, see 'Activating Manual Fan'.
Setting Cab Temperature
The display (1) shows the currently set temperature.
To decrease temperature:
• Press button (6)
To increase temperature:
• Press button (7)
Temperature may be adjusted in 1°C or 2°F
increments depending on units selected (See
'Changing the temperature unit') per press of button.
The automatic air conditioner adjusts the cab
temperature to the set value. During this process,
the fan speed may rise quickly so that the cab
temperature reaches the pre-set set point more
quickly. Such as on a very hot day. When the cab
temperature approaches the set value, the fan speed
will be reduced again.
Switching Temperature Display
The temperature display can be switched between
degrees Celcius and degrees Farenheit.
• Press buttons (4) and (6) simultaneously for up to
3 seconds to switch between unit modes
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Repeating the above step will cycle between the two
unit modes.
Displaying Outside Temperature
Press button (4). Indicator light (4) lights up. The
display (1) shows the outside temperature.
Adjusting Air Conditioner Air
Flow
The air flow is distributed inside the cab by fully
adjustable nozzles. Each nozzle can be adjusted
directionally or turned on/off to suit the individual
needs of the user, e.g. to heat the leg area, close all
upper vents and direct air flow from the lower vents
to the floor.
Chapter 4 - Cabin - 23