End Of Day; End Of Program - Goldacres Crop Cruiser G6 Operator's Manual

End of Day

At the end of the spraying day, follow the flushing
and decontamination procedure as per previous
instructions.
1. Unfold the boom in an area convenient to
dispose of residual chemical (an area where
chemical can not run-off into above ground or
sub surface water courses).
2. Clean all filters.
3. Clean all nozzles.
4. Wash down unit.
5. Drain main tank.
6. Drain the pressure filters.

End of Program

If the sprayer is to be stored for a long period of
time without use, there are several tasks that need
to be performed.
• Clean the sprayer thoroughly as described under
'End of Day' tasks.
• Carry out a thorough observation to determine if
there is any damage to the sprayer.
• Park the sprayer in a position where it will not
be affected by frosts, and preferably out of direct
sunlight.
• Ensure the main tank and any other tanks fitted
are empty.
If necessary, remove consoles from cabin and store
in a safe and secure location. Protect hydraulic hoses
and electrical connections.
NOTE: Store the sprayer in a suitable location to
prevent freezing. If the sprayer is to be left where
freezing may occur, cover the pump and flow meter
with a material bag and empty pump and flow meter
of all water (run the pump dry for 15-20 seconds). It
is also suggested that a small quantity of anti freeze
be added to the main tank and circulated through
the sprayer to minimise the chance of freezing.
Make sure any ice has thawed before using
sprayer.
96 - Chapter 8 - Operation G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0