Transmission - Goldacres Crop Cruiser G6 Operator's Manual

shallow

Transmission

The Allison 6 speed automatic transmission oil level
can be checked by using the dipstick located in front
of the cabin on the left hand side.
The oil level must be checked with the engine
running. If the oil is cold (less than 70 degrees
Celsius) the oil level must be in the lower range.
If the oil temperature is warm (above 70 degrees
Celsius) the oil level must be in the upper range.
External Filter Replacement
1. Remove the spin-on external filter by rotating it in
the counter-clockwise direction. A standard strap-
type wrench may be used.
2. Remove the magnet from the filter attachment
tube or the top of the filter element.
3. Clean any metal debris from the magnet. Any
metal pieces found larger than dust needs to be
further investigated.
4. Reinstall the magnet onto the filter attachment
tube.
5. Lubricate the gasket on the filter with a thin film
of transmission fluid.
6. Install, by hand, the filter until the gasket touches
turning the control main Filter more than one Full turn after gasket contact
the converter housing or cooler manifold.
IMPORTANT: Turning the filter more than one full
turn after gasket contact will damage it.
7. Turn the filter ONE FULL TURN ONLY after
gasket contact.
8. Reinstall the drain plug and sealing washer. Tighten
the drain plug to 30-40 Nm (22-30 lb ft).
9. Refill transmission. Refer to end of chapter for fill
quantity and fluid specifications.
Transmission Oil Cooler
The transmission oil cooler is integrated into the
radiator.
NOTE: Refer to the maintenance schedules and
the Lubricants and Filters tables at the end of this
chapter for servicing details.
NOTE: Refer to the Allison Transmission operation
and codes manual (supplied) for any information
on operation or troubleshooting the Allison
transmission.
120 - Chapter 10 - Lubrication & Maintenance
12 12.7 7
MAGNET
FILTER
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
7.4
V05805