Fill Flow Meter - 70 Series - Goldacres Crop Cruiser G6 Operator's Manual

70 series fill flow meter

Fill Flow Meter - 70 Series

Key Features
The Tee Jet monitor and flow meter system can be set up to measure the amount of flow entering the main
spray system or it can be set up with a supplementary electronic ball valve that will shut off when a pre
determined volume is reached preventing over filling of the sprayer.
When the flow meter system is connected without the ball valve the flow meter is not required to be turned
on to fill the tank. However when the electronic ball valve is part of the system the console must be powered
on and the target volume must be set to open the ball valve and allow liquid to flow through and fill the tank. If
this is not done the ball valve will remain closed, blocking flow to the main tank and dead heading the fill pump.
The console can be programmed to reset to the maximum tank volume every time the filling process is
activated. If a lesser amount is required then the maximum volume can be reduced to the required amount.
When this amount is reached an alarm will sound. If the system has a ball valve, the valve will shut off stopping
flow to the main tank. If the valve is not fitted the [CLR] button can be pressed to silence the alarm.
Operation
Button Functions
ON
CLEAR
Start Up Screen
SOFTWARE
VERSION
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
INCREASE
PRESS
TOGETHER TO
TURN OFF
DECREASE
Continued over page
Chapter 12 - Optional Accessories - 167