Goldacres Crop Cruiser G6 Operator's Manual page 39

CANtrak System
NO.
1.
2.
3.
4.
5.
Left to right: Key 1-5, examples of screen images after keys are pushed.
Getting Started
When power is applied to the display, a start-up
screen displays for approximately 7 seconds while
the unit performs a self test . If the unit makes a
long 'beeping' sound, self-test has failed. Users can
attempt to rectify the fault by restoring factory
defaults (see Configuration section); if the fault
persists, contact your supplier for guidance.
The 'Splash Screen' is displayed on boot up.
After the start up screen disappears, GEM starts
displaying readings on its virtual gauges if it is
connected to an active source of data. GEM displays
the 'main engine display' or tri-screen on initial start
up, but note that after use this changes to the screen
that was last displayed (see Preferred Screen Store
section for details). GEM display modes are detailed
in the following sections.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
1 2 3
FEATURE
Tri Display, or Main Engine Display
Quad Display
Uni Display
Active alarm display
Contrast and Lighting Adjustment
4 5
FUNCTION
Repeat presses cycle the fuel
computer through various modes.
(User configurable). Repeat presses
cycle the display around 3 different
quad view options..
Showing data history (configurable).
Repeat presses cycle display through
available parameters.
Holding the button brings up stored
alarms..
Or - if held for 3 seconds - the
configuration menu..
GEM Soft Keys
GEM's soft keys simplify the operator interface. In
use, GEM displays a 'button bar' directly above the
soft keys when any of the first 4 keys (keys 1 to
4, starting from the left) are pressed - with icons
representing the current function of each key. The
picture at the top of the page shows the main
button bar, with icons 1 to 4 representing the gauges
and alarms available, and icon 5 an 'exit door'. Repeat
presses of these buttons toggles around the display
options available. The button bar will disappear
after approximately 5 seconds if no further keys are
pressed.
GEM presents a context
dependent 'button bar' above
the push buttons if any key
from 1 to 4 is pressed - it
disappears after 5 seconds of
inactivity. This 'top level' button
bar shows the basic structure
of GEM:
Continued over page
Chapter 4 - Cabin - 35