Goldacres Crop Cruiser G6 Operator's Manual page 182

Groeneveld Auto Greaser - Components
Return Valve
The return valve indicated in the photograph below
allows grease to return to the reservoir from the
grease line when pressure is released at the end of
the lubrication cycle.
Above: Return valve
NOTE: Removing this blank is not advised. There
is a check ball held in under spring tension that will
come out at some speed. If this is lost, the return
valve and non return valve will not work and the
system will pump the grease back to the reservoir. If
you believe there is a problem with this part of the
system, contact your Groeneveld dealer direct.
WARNING: Removing this blank is not advised.
There is a check ball held in under spring tension
that will come out at some speed. Eye injury may
result from the ball bearing if the blank is removed. If
you believe there is a problem with this part of the
system, contact your Groeneveld dealer direct.
178 - Chapter 12 - Optional Accessories
Second Grease Outlet
A second grease outlet is on the pump unit and
shown in the photograph below, in this case it is
covered by the brass blank indicated. The main
grease line is indicated by the arrow to the right of
the blank.
NOTE: If you decide you want to run a second
grease outlet line, please contact your Groeneveld
dealer directly for technical advice.
Above: Second grease outlet
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Continued over page