Goldacres Crop Cruiser G6 Operator's Manual page 173

Fill Flow Meter - 70 Series
3. To do this, press 'PRO' and hold down for 3 seconds. Using the up and down arrows adjust the number so
that it matches the flow meter calibration figure (pulses/liter).
4. Press the 'PRO' button once the correct calibration number has been entered. This will take you to the next
screen but will also set the calibration figure that was just entered. (To save the flow meter cal figure, the
'Pro' button must be pressed once. Dont press and hold the 'PRO' button to exit from this screen or changes
wont be saved. See step 6 for exiting calibration.)
5. When in this screen, the maximum target volume is set. This is used as a quick reset to the tanks maximum
volume. Use the up and down arrows to set the required maximum tank volume.
6. Once all calibrations have been entered, press and hold 'PRO' for 3 seconds to go back to the fill screen.
(shown below, numbers shown here may vary to what is displayed on your screen)
7. To set the target volume, press 'PRO' once so the target value flashes. Use the arrows to adjust the value.
Press 'PRO' when value is reached.
8. Press up and down arrows simultaneously to turn off.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Continued over page
Chapter 12 - Optional Accessories - 169