Transmission - Goldacres Crop Cruiser G6 Operator's Manual

Transmission

The operator must wear the operator safety belt
at all times when seated in the cabin or when the
machine is in motion. To engage a gear from neutral,
first apply the foot service brake located to the right
of the steering column, then release the park brake
and press the 'D' button on the gear selector to
drive forward or 'R' to reverse.
Select
u
Display
SELECT DISPLAY
This LED Character shows which gear has been
selected by the operator. It will display D, R, or N or
a number reflecting the specific gear. P is typically
not displayed for Park – the P only appears on the
MONITOR DISPLAY side.
MONITOR DISPLAY
This LED character shows which transmission gear is
currently engaged. This includes P, R, N, and numerical
values for forward gears. This side typically does not
display D for Drive – it allows the operator to glance
down and see the specific gear they are currently
using.
TRANSMISSION FAULT WARNING
If the SERVICE indicator is illuminated then there is a
fault in the shift by wire system. A qualified technician
should inspect the system as soon as possible.
WARNING: Operating the machine with the
wrench icon flashing is not recommended. It may
indicate a loss of safety back up systems, and the
operator should use extra caution when shifting to
ensure that the transmission is performing properly.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Monitor
u
Display
Service
u
Indicator
Reverse gear.
Neutral; the gear selector must be in this
position for starting.
Drive, in this position 1st - 6th gears are
available and will be selected by the ECM
when required. Overdrive gears 5th & 6th
will only be engaged when in ROAD
MODE.
Gear UP. Press to manually upshift one
gear at a time until top gear is selected
when the transmission is in Drive. The
SELECT display will show which gear range
has been selected, and the MONITOR
display will show which transmission gear is
currently engaged.
NOTE: The transmission will not shift
above the gear range selected. When Drive
(D) is selected the full range automatic
shifting is restored.
Gear DOWN. Press to manually downshift
the transmission one gear at a time until
1st gear is selected.
The SELECT display will show which
gear range has been selected and the
MONITOR display will show which
transmission gear is currently engaged.
NOTE: The transmission will not shift
above the gear range selected. When Drive
(D) is selected the full range automatic
shifting is restored.
This button is NOT FUNCTIONAL. A light
in the top right corner will cycle ON/OFF
when pressed, but is not connected to any
function on the machine.
SPRAY MODE / ROAD MODE
Rock the switch forward to engage SPRAY
MODE. The transmission will only go to
4th gear for spraying speed. Rock the
switch back to engage ROAD MODE.
Transmission will shift through full range
including 5th & 6th gear for speeds up to
50Km/h.
Chapter 8 - Operation - 83