Chemical Transfer Pump - Goldacres Crop Cruiser G6 Operator's Manual

Chemical Transfer Pump

Overview
The Transfer Pump is used to transfer chemical
to the main tank, in place of the venturi chemical
probe. Combined with an FM-1100 flow meter,
its an accurate way of measuring chemical being
transferred into the main tank.
Pump Specifications:
• Flow rate - Up to 45 L/min
• Head - To 3.0 m
• Pressure - To 1.0 bar
NOTE: Sotera stainless steel rotary vane pumps
are designed for maximum practical corrosion
protection with a wide range of thin liquids. .
However, ensure chemical compatibility between
liquids pumped and the pumps wetted parts before
using.
NOTE: Do not use the pump to transfer flammable
petroleum products.
Operation
CAUTION: Exposure to chemical can cause serious
injuries, always wear proper protective clothing and
devices when transferring chemical. Refer to and
follow chemical manufacturers instructions.
1. Connect chemical probe to cam lock fitting on
sprayer.
2. Put other end of probe into the chemical to be
transferred.
3. Turn Chemical Induction handle to PUMP.
4. Turn on pump and open valve on chemical probe
and valve behind cam lock fitting.
5. Transfer desired amount of chemical. Pull probe
out of chemical and let the pump run until all
chemical has been sucked from lines.
6. When all of the chemical has been transferred,
rinse the chemical container with water and
transfer the rinsate to the sprayer tank via the
probe. This should ensure that the entire chemical
is transferred and that the probe, pump and
connecting suction hose are cleaned. Induct clean
water to rinse probe vacuum hose.
160 - Chapter 12 - Optional Accessories
7. Turn pump off, close both valves and disconnect
chemical probe.
1 2
NOTE: Do not use the pump with fluids that have a
flash point lower than 37 degrees C (100 degrees F).
A
B
C
D
Above: Sotera chemical transfer pump (GA5072100).
E
F
REV. DESCRIPTION
REVISIONS
1 2
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
3 4
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE
IN MILLIMETRES
DATE ECN N°
THIS DRAWING REMAINS THE PROPERTY
OF GOLDACRES TRADING PTY LTD AND IS
SUBJECT OF COPYRIGHT
3 4
5
UNTOL. DIMENSIONS
Material Drawn By:
:
OPEN DIM ± 1.00
Surface Finish: Drawing Checked:
ANGULAR ± 0.50°
UNLESS OTHERWISE
Approved
TOLERANCED
DRG. STANDARD
/PRACTICE
DATE EDITED:
DEBUR ALL EDGES
AS 1100 NealHarvey
6
27/10/201
27/10/201