Groeneveld Auto Greaser - Components - Goldacres Crop Cruiser G6 Operator's Manual

Groeneveld Auto Greaser - Components

The COMPONENTS section will give you a basic
run down of the components, their location and
their purpose. A full operational description of the
system is in the OPERATION section. Some settings,
tips and words of advice and caution are also listed
where applicable at each component's section. Please
familiarise yourself with this area thoroughly.
Pump Unit
The Pump Unit is made up of the following parts –
the main storage area, the metered reservoir where
the next grease dose is held, main piston, follower
plate, compressed air inlet, fill point and return / non
Pump Unit
Red tag bung must be removed
174 - Chapter 12 - Optional Accessories
return valves. The purpose and operation of these
will be explained in the manual.
The filling point is on the left side of the pump unit
and should be covered with a protective cap.
Before filling, ensure you read and understand the
following note and cautions:
IMPORTANT: When you take delivery of your
sprayer, ensure you check the right hand side of the
pump unit and look for a red tag or an over flow
hole. If the red tag is still fitted, REMOVE IT now. If it
is left in place, the reservoir may fail on refilling due
to pressure build up.
Fill
Point
Unplugged overflow hole
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Continued over page