Transfer Case - 4Wd - Goldacres Crop Cruiser G6 Operator's Manual

Transfer Case - 4WD

The transfer case directs drive from the transmission
to the front and rear axles on machines fitted with
four wheel drive.
The transfer case runs an oil bath sump. The oil
level can be checked by removing the oil level plug
located on the side of the transfer case.
The oil should be replaced at the first service to
remove any manufacturing contamination.
When draining the oil, the machine should be driven
for a short time before hand to warm up the oil. This
allows it to drain easier. Remove both the drain and
fill plugs when draining the oil.
When filling the transfer case, the machine should be
parked on level ground. Fill up to the oil level plug.
Clean the oil level plug before refitting.
NOTE: See 'Recommended Lubricants' section at
end of this chapter for lubricant specifications.
Fill
plug
Drain plug (underside)
An air solenoid is located behind the right hand side
Pod. When the centre differential lock is switched on
in the cab, the solenoid is activated. This then sends
air from the solenoid, down to the shift cylinder on
the transfer case. The cylinder is pushed in by the air
and the lock is engaged.
This solenoid can be manually overridden if required.
Locate the solenoid under the chassis as shown. The
override screw is on the bottom. Using a flat head
screw driver, push up into the screw and turn a 1/4
turn in either direction.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
1
Air should now be flowing through the solenoid and
the differential lock should be engaged.
A
To disengage, turn the screw a 1/4 turn in the
opposite direction to when it was overridden.
Ladder valve
B
4WD valve
C Adjustment screw
Above: Pneumatic manifold located behind the right
hand side Pod. The 4WD solenoid has an override
screw in the bottom that can be overridden with a
flat head screwdriver.
D
REV NO CHANGE
1
Chapter 10 - Lubrication & Maintenance - 121
2 3
UNTOL. DIMENSIONS
OPEN DIM ± 1.00
ANGULAR ± 0.50°
UNLESS OTHERWISE
TOLERANCED
UNLESS OTHERWISE
SPECIFIED:
NAME/DATE ECN
DIMENSIONS ARE IN
MILLIMETRES
2
DEBUR ALL EDGES
4
MATERIAL: Drawn By:
C.Turner 20/09/2011
Surface Finish: Drawing Checked:
Approved:
DRG.
STANDARD
/PRACTICE
Date Edited:
AS 1100
5/05/2017
NealHarvey
THIS DRAWING REMAINS THE PROPERTY OF GOLDACRES
TRADING PTY LTD AND IS SUBJECT OF COPYRIGHT