Cantrak System - Configuration - Goldacres Crop Cruiser G6 Operator's Manual

CANtrak System - Configuration

Configuration Menu
This mode allows users to set various GEM
operating parameters such as imperial or metric
units, scale limits for the speedometer, engine service
interval, etc. The configuration menu is entered by
pressing and holding key 5 ('Exit door' icon) for at
least 3 seconds while GEM is in normal operating
mode. The top-level configuration menu will be
displayed as shown below. Use Keys 1 and 2 (up
and down arrows) to point to either SETTINGS
Above: The top-level Configuration menu showing two choices of SETTINGS and SYSTEM sub-menus.
Pressing Key 4 enters the menu highlighted. Key 5 showing the 'exit door' icon returns you to the previous
menu.
Settings Sub-Menu
The settings sub-menu allows the user to configure
or view the following items:
UNITS: Speed, distance, pressure, volume, etc.
LANGUAGE: Choose from various language options
BEEP: Keys "beep" when pressed (toggles on or off);
note that an audible beep still sounds if an alarm
occurs
DISPLAY: Select ranges for max. RPM, max. speed,
and graph X axis
SERVICE: Set service interval in hours, and reset
interval counter
FUEL CAPACITY: Adjust tank capacity and reset
tank level to full
50 - Chapter 4 - Cabin
or SYSTEM sub-menus. Press key 4 to enter the
selected sub-menu. User preferences are set in
SETTINGS sub-menu. SYSTEM sub-menu accesses
maintenance and low-level system configuration
settings. These sub-menus are detailed below. Key 5
('Exit door' icon) exits the current menu/sub menu.
Settings are automatically stored on exit.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Continued over page