Goldacres Crop Cruiser G6 Operator's Manual page 192

Groeneveld Auto Greaser - Maintenance & Testing
7. Replace the dust cap on the filler connector.
8. There is a filter within the filler connector in the
reservoir. If pumping is very difficult, the filter
could be blocked. In this case, dismantle and clean
the filter.
Right: Filling the
pump unit.
Testing Electronic Timer
STEP SWITCH TEST
This checks the step switch contacts in all positions.
1. Set the step switch to position 'test A'.
2. Activate the electronic timer by switching on the
ignition.
3. Press the 'test' button.
4. Wait for the audible alarm signal then release the
'test' button.
5. Within 5 seconds turn the step switch to the
required interval time position. Each position
produces a number of signals: position 1 gives one
signal, position 2 two signals etc.
6. The switch can be set to all positions. Positions
'test A' and 'test B' will not produce an alarm
signal.
7. End the test by switching off the ignition.
ACCELERATED CYCLE TEST
This allows you to test a timing cycle without waiting
the full set time interval. It sets the time interval at
1/20th of its duration.
1. Set the step switch to position 'test A'.
2. Press and hold the 'test' button.
188 - Chapter 12 - Optional Accessories
1
3. Switch the ignition on while still keeping the 'test'
4. The alarm signal buzzer will now sound. The 'test'
5. Within 5 seconds of the end of the alarm signal
6. The electronic timer is now fully operational; the
7. End the test by switching off the power supply.
NORMAL SYSTEM TEST
1. Switch the ignition on.
2. Press the 'test' button; a normal lubrication cycle
After this test the electronic timer will work at the
interval set.
The 'test B' position is only for use with the test or
read-out unit.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
2
button pressed in.
button must be pressed as long as the alarm
signal continues.
turn the step switch to the required position.
time intervals are now 1/20th of their usual times.
will then follow. The switch can be set in any
position except 'test A' or 'test B'.