Goldacres Crop Cruiser G6 Operator's Manual page 56

CANtrak System - Configuration
Pop Up Messages & Warnings
• Engine service warning. In the Configuration
menu, users can set the engine service interval in
hours. When GEM determines an engine service
is due, it displays SERVICE REQUIRED on the
splash screen that appears at power-up.
• Data communications failure. If GEM cannot
detect engine/ transmission data broadcasts , a
pop-up window with a data communications
failure warning icon will appear and flash. Once
engine/transmission data is detected the warning
disappears and normal data display resumes.
• CAN TX disable. If CAN TX (transmission) is
disabled, then the status will be displayed, with
a pop-up window flashing with a period of
approximately 1 second on, 10 seconds off. Note
that this function is a requirement of the J1939
specification and is not normally of importance
for GEM applications.
• Data not supported. If the required data
parameter is not available, the gauge will display
" - - - " near the units and parameter icon (see
centre picture for example)
Above, top to bottom: Pop up warnings - Engine
service required, a data communications failure and
CANTX is disabled.
52 - Chapter 4 - Cabin
Setting LCD Lighting & Contrast
Pressing key 5 (the right-hand key) when the menu
icons are not being displayed brings up the lighting
and contrast menu. The LCD has a number of back-
lighting levels that allow the display to be read in the
dark. The appropriate level is selected by pressing
keys 1 or 2 to decrease or increase illumination.
Contrast is adjusted in the same manner, using keys
3 and 4 (Figure 12.1). Note that GEM monitors the
temperature of the LCD and automatically adjusts
display contrast as required, therefore it is not likely
that a user will need to make a manual contrast
adjustment unless extreme climate changes occur.
The menu is exited by pressing key 5. The lighting
and contrast settings are retained after the unit is
switched off.
NOTE: resetting contrast. If the contrast has been
adjusted poorly, you may restore the factory
setting (a central value) by pressing keys 1 to 4
simultaneously. This action does not change other
user-configured settings.
NOTE: The backlight can be set to Auto or ON.
Above: Contrast level adjustment on the lighting and
adjust screen.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Continued over page