Chemical Transfer Flow Meter & Pump-Troubleshoot - Goldacres Crop Cruiser G6 Operator's Manual

Chemical Transfer Flow Meter & Pump -
Troubleshooting
PROBLEM
Meter display will not turn on:
Meter shows no flow: (pump runs)
Flow low/high/inconsistent:
Meter leaks:
Noisy / rough operation:
164 - Chapter 12 - Optional Accessories
COMMON SOLUTIONS
Check for dead battery.
Check electronics chamber for moisture.
Check O-ring seal for damage.
Check to see that PCB assembly is properly seated.
Check to see that battery is properly seated / no corrosion.
Check for damaged magnetic switch/PCB.
Check low battery indicator.
Check for damaged magnetic switch/PCB.
Check magnetic wheel assembly.
Check nutating chamber for debris.
Check to see if outlet tube is severely restricted (kinked).
Check for missing magnet wheel assembly.
Check to see if out of product.
Check for air in system.
Check for calibration error (Err).
Check for particulates in fluid.
Check for damaged nutating chamber.
Check for damaged O-ring.
Check for loose screws.
Check inlet/outlet fittings for proper seal.
Check meter housing for cracks.
Check nutating chamber for debris.
Check for loose magnetic wheel assembly.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0