Goldacres Crop Cruiser G6 Operator's Manual page 55

CANtrak System - Configuration
System Sub-Menu
The system sub-menu allows the user to configure
or view the following items:
DEMO: Switches between GEM's demonstration
mode and the normal mode of displaying live engine/
transmission data. Demo allows GEM to operate
without live data and provides 3 levels of simulated
data: 1 = Speed On; 2 = Speed Off; 3 = Alarms
On. Demo is automatically set to OFF if live data
is received. DEMO mode can be selected, allowing
you to evaluate GEM without connecting an engine/
transmission (it is accessed via the Configuration
menu described above). If the unit is in DEMO mode
and live data from the engine/ transmission becomes
active, DEMO mode will automatically be switched
off.
RESTORE DEFAULTS: Allows you to reset all
configuration information to default metric or
imperial values. The default settings are:
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
COM VIEWER: Displays last messages received
on J1939 (CAN) and NMEA 0183 (GPS - derived
speed over ground data) ports. You can also
view GEM's database (DB) which stores all data
transmitted from the engine/transmission.
NOTE: this is a diagnostic feature that may be
helpful for OEMs/users diagnosing faults.
J1939 SETTINGS: J1939 configuration screen
for engine and transmission source: 1 = engine
1 (port), 2 = engine 2 (Starboard); alarm filter
(GLB (Global) = all alarm sources, SRC = selected
engine/ transmission only); SPN version (4 is default
but older engines will need to be set to 1, 2 or
3 as appropriate). Note. Consult your engine or
vehicle supplier to establish which SPN version is
appropriate if you have problems reading alarm data.
ABOUT: Displays the following product information:
• ID NO: Unique number of the display
• EEPROM: Number of write cycles
• PART No: Software part number
• VERS: Software version number
• CHK: Flash memory checksum
• SOURCE: The source of received data
• LIB1: Low level system library version
• LIB2: Low-level graphical display interface library
version (if used).
Continued over page
Chapter 4 - Cabin - 51