Air Conditioning - Goldacres Crop Cruiser G6 Operator's Manual

Air Conditioning

The automatic air conditioner regulates the
temperature and humidity of the air in the cabin.
The following operating modes are available:
• Fully automatic
Ideal for high outside temperatures.
• Manual ventilation system
Automatic mode with manual fan speed setting.
• ECON
Automatic mode without cooling function.
• Drying the cab windows
Continuous compressor operation at maximum fan
speed
Activating Automatic Air
Conditioner
Switch the ignition on and start the engine.
After switching the ignition on, the software version
appears in the display (1) for 3 seconds.
After that, the unit carries out a self-test which takes
20 seconds max. The keys are now enabled for
operation.
The operating mode and the display will remember
the same settings from the last time the machine
was running.
In fully automatic mode the air conditioner
compressor, heater and the ventilation are
automatically controlled so that the pre-set cab
temperature is achieved as quickly as possible and
then kept constant.
This operating mode is ideal at high outside
temperatures.
22 - Chapter 4 - Cabin
1
3 4
6 5
2
8 9
7
Activating fully automatic operation:
• Switch off cab windows drying (3), manual
ventilation (8) and ECON (9) operating modes
The indicator lights (3), (8) and (9) are OFF.
Indicator light (2) lights up. Fully automatic mode is
active.
At outside temperatures below 10°C, the automatic
system shuts down the air conditioner compressor.
Activating Manual Fan
In manual fan operation, the heater and depending
on the setting, the air conditioner compressor are
automatically regulated to the pre-set set point. The
fan speed can be set manually.
This offers the opportunity of setting a lower
fan speed and slower temperature adaptation in
case of large deviations between cab and outside
temperature.
Activating the manual fan:
• Press button (8)
Indicator light (8) lights up. Manual venting is active.
Current fan speed is shown on the display (5). One
bar represents a 10% speed increment between 0
and 100 %.
To reduce the fan speed:
• Press button (6) once per 10% speed decrease
To increase the fan speed:
• Press button (7) once per 10% speed increase
The changed setting is activated after 5 seconds.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Continued over page