Goldacres Crop Cruiser G6 Operator's Manual page 167

will both blink together. Numeric Display will also
show a value (XXXX), which represents the present
value stored in flow meter's memory.
the value shown in Numeric Display to desired value.
Chemical Transfer Flow Meter
press MODE button for 3–5 seconds. CALIBRATE
4. CALIBRATE (CAL) and COUNTS (CNT)
(CAL) and COUNTS (CNT) indicators will turn off and
indicators will both blink together. Numeric
display will show CAL if CALIBRATION was successful.
Display will also show a value (XXXX), which
represents the present value stored in flow
meter's memory.
5. Press INCREASE or DECREASE buttons to
change the value shown in Numeric Display to
desired value.
6. To complete CALIBRATION for COUNTS (CNT),
press MODE button for 3–5 seconds.
CALIBRATE (CAL) and COUNTS (CNT)
indicators will turn off and display will show CAL
if CALIBRATION was successful.
NOTE: If MODE button is pressed for less than 3
seconds, CALIBRATION will be aborted and display
will show Err (Error) to indicate the CALIBRATION
was not successful. Display will return to CURRENT
TOTAL (CUR) without making any changes.
To purchase parts, please contact our Sales Department at 800-424-9776.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
FM-1100 & FM-1100i Kits List / Parts Drawing
2
1
To Display Software Revision Number
1. Press MODE button to turn meter on.
2. Press MODE button again to display CUMULATIVE
TOTAL (CUM).
3. While display is showing CUMULATIVE TOTAL
(CUM), press and hold DECREASE button to display
flow meter's software revision number (e.g. r1.00).
To Display Software Revision
CUMULATIVE TOTAL CANNOT BE RESET - EVEN BY
Number
REMOVING THE BATTERIES.
1. Press MODE button to turn meter on.
2. Press MODE button again to display
CUMULATIVE TOTAL (CUM).
3. While display is showing CUMULATIVE TOTAL
(CUM), press and hold DECREASE button to
display flow meter's software revision number
(e.g. r1.00).
NOTE: CUMULATIVE TOTAL CANNOT BE RESET
- EVEN BY REMOVING THE BATTERIES.
4a
3
Reference only
8
4b
Chapter 12 - Optional Accessories - 163