Goldacres Crop Cruiser G6 Operator's Manual page 112

Boom Adjustment
OUTER BOOMS
• The height of the outer booms in the working
position are adjusted by adding or removing shims
at the cable drum.
• The cable drum mounts are assembled in
manufacturing with 6-7 shims at the upper and
lower bearing blocks.
• If the outer boom hangs lower than the inner
boom, remove shims from the upper mount until
the booms are level. If the outer boom is too
high remove shims from the lower bearing block.
Retension the retaining bolts to 65 Nm when all
adjustments are complete.
• The boom cables may need to be loosened to
enable easier removal of the shims.
For 24-30 m booms:
1 shim added = 10-20 mm change at boom end
For 33-36 m booms:
1 shim added = 20-30 mm change at boom end
108 - Chapter 9 - Boom
4 5
To raise the outer boom,
A
remove shims from the top pivot
To lower the outer boom, remove
B
shims from the lower pivot
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
6 7