Table of Contents
Advertisement
REPLACEMENTS
11
. Loosen the 2 ALLEN SCREWS of the PULLEY and take off the PULLEY. Take off
the CIRCLIP.
12
. Take off the BEARING.
13
. Take out the 4 SCREWS of the BEARING MOUNT.
14
. Take out the Bearing Mount.
15
. Move TRANSPORT SHAFT ASSY to the right, so that the left end comes free.
16
. Take out the TRANSPORT SHAFT ASSY.
17
. Install the new TRANSPORT SHAFT ASSY.
18
. Install both VACUUM PUMPS.
Function Test
1
.
Run a complete CYCLE with the largest FILM available.
2
.
Check processed FILM for artefacts
REPLACEMENT TRANSFORMER T1
1
.
Power down and unplug the ML 700
2
.
Open FRONT DOOR
3
.
Unlock DRAWER and pull it out completely
4
.
Take HEX SCREW and TORX SCREW out and remove the TRANSFORMER COVER.
See the top drawing on the next page.
5
.
Make a note on how the TRANSFORMER is wired.
6
.
Disconnect TRANSFORMER.
7
.
Take out the 4 HEX TRANSFORMER MOUNTING SCREWS.
8
.
Pull out the TRANSFORMER to the front.
KODAK AG, Stuttgart
2-47
3053-3
12/1998
Advertisement
Table of Contents
