Table of Contents
Advertisement
3053-3
Note
Do not set the gain too high. It might be possible that the INFRARED LIGHT BEAM is
reflected by FILM in a MAGAZINE triggering the SENSOR and recognising the MAGAZINE
as being empty.
7
.
Rotate the GAIN ADJUSTMENT SCREW of SENSOR B10 (ME) count counter until
the indicator LED turns red. Now turn the GAIN ADJUSTMENT SCREW 1 step
clockwise so that the INDICATOR LED turns green.
Note
The green SENSOR LED will be turned on in MAGAZINE LEVEL 1 if the FILM POCKET
SUCKER BAR is not rotated fully in. The SENSOR will see INFRARED LIGHT reflected from
the MBF REFLECTIVE STICKER at this time. This is no fault. The signal of SENSOR B10
(ME) is only valid if the FILM POCKET SUCKER BAR is in the MSI POSITION.
8
.
Check this adjustment in MAGAZINE LEVEL 1. It is possible that the INFRAFRED
BEAM will be reflected by the REFLECTOR for SENSOR MAGAZINE BLOCKED BY
FILM. If this occurs readjust the position of the MIRROR and the SENSOR B10 (ME).
9
.
Leave the SERVICE MODE.
10
. Key in 3585 to bring all MOTORS to HOME POSITION.
FILM POCKET STEPPER MOTOR M8
PURPOSE:
To set the current of the FILM POCKET STEPPER MOTOR M8 to the correct value.
1
.
Enter the SERVICE MODE.
2
.
Key in 7, 8, 1, 2, (Move FILM POCKET to LEVEL 2).
3
.
Connect the DVM to TP1 and R22 on PCB A3. See the top drawing on the next page.
4
.
Key in 3 to move the FILM POCKET to the HOME POSITION. During the movement
of the STEPPER MOTOR the DVM reading has to be 1.64 to 1.67V. If not adjust R23.
12/1998
4-70
ADJUSTMENTS
KODAK AG, Stuttgart
Advertisement
Table of Contents
