Table of Contents
Advertisement
REPLACEMENTS
6
.
Slide the right-hand FILM REJECTER to the right. This allows to take out the
CLUTCH SPRING. If the REJECTER cannot be slid enough to the right to take out
the SPRING, take off the C-RING and WASHER at the left-hand FILM REJECTER.
7
.
Clean the surface of the CLUTCH RING and lubricate it with a small amount of
PLASTILUBE with MOLY TL2201.
8
.
Install the new CLUTCH SPRING.
9
.
Move the COLLAR fully to the left and tighten the SET SCREW. If you took off the
C-RING and WASHER in step 6, mount it now.
10.
Mount all PANELS.
FUNCTION TEST
1
.
Run several cycles with different FILM sizes.
REPLACEMENT MAGAZINE SUCKERS
1
.
Switch off the ML700.
2
.
Take off the REAR PANEL.
Note
Do not bend the FILM POCKET MECHANISM
3
.
Carefully take off all 4 MAGAZINE SUCKERS and discard them.
4
.
Mount the 4 new SUCKERS.
5
.
Use the SUCKER GAUGE to ensure that the inner surface of all 4 SUCKERS have
the same distance from the SUCKER BAR.
The SUCKER GAUGE gives the dis-
tance between the inner surface of the
SUCKER and the SUCKER BAR. Do
not measure from the SUCKER LIP
to the SUCKER BAR.
KODAK AG, Stuttgart
figure 2-30
2-35
3053-3
SUCKER
MAGAZINE SUCKER
SUCKER GAUGE
12/1998
Advertisement
Table of Contents
