ADJUSTMENTS
6
.
Fasten MOUNTING SCREWS.
CASSETTE BELT MOTOR M1
PURPOSE:
The DRIVE SHAFT of the MOTOR should be aligned with the DRIVE SHAFT of the BELT.
1
.
Loosen MOUNTING SCREWS of the M1 MOTOR MOUNTING BRACKET.
2
.
Move MOUNTING BRACKET, until MOTOR DRIVE SHAFT is aligned with BELT
DRIVE SHAFT.
3
.
Fasten MOUNTING SCREWS.
CASSETTE END SWITCH S13 (CES)
PURPOSE:
The CASSETTE END SWITCH should be actuated when the CASSETTE is 0.5 - 1 mm away
from the CASSETTE STOP. Check that it is only actuated when both ACTUATORS are
pushed back.
KODAK AG, Stuttgart
figure 4-10
4-9
3053-3
12/1998