Table of Contents
Advertisement
ADJUSTMENTS
CASSETTE CENTRING BRAKE (ML700 with Mod 26 and ML700
Plus)
PURPOSE:
To ensure that the CASSETTE is centred properly and that there is a gap
of 1 - 2 mm between the CASSETTE 18x24 cm X and the CENTRING BARS
on each side.
Note
•
This gap is smaller if larger CASSETTES are used
•
Check the ADJUSTMENT OF CASSETTE CENTRING STOP SWITCHES S14/15 (CCS)
first.
•
No FILMS are required for this adjustment
Required Tools:
WRENCH 8 mm. Use WRENCH KIT PN G9901934 or TL2765.
1
.
Open the ML700 FRONT DOOR and take out the 7 Magazines to avoid fogging of
fresh Films and close the FRONT DOOR.
2
.
Open the ML700 TOP COVER.
3
.
Take off the ML700 left-hand SIDE PANEL.
4
.
Actuate the INTERLOCK OVERRIDE SWITCH.
5
.
Check that the BRAKE STOP just touches the BRAKE BELT TENSIONER. If it does
not touch loosen the 2 MOUNTING SCREWS and move the BRAKE STOP in as
required. Tighten the SCREWS.
BRAKE BELT TENSIONER
KODAK AG, Stuttgart
BRAKE STOP
figure 4-14
4-13
3053-3
MOUNTING SCREWS
12/1998
Advertisement
Table of Contents
