Table of Contents
Advertisement
ADJUSTMENTS
5
.
Tighten LOCK NUT.
6
.
Reinstall SENSOR MOUNT with INDUCTIVE SENSOR.
7
.
Adjust the SET SCREW until the SENSOR GUIDE RING is 13 mm above the BELT.
8
.
Adjust the SET SCREW from step 7 until the GUIDE RING touches the thinnest
CASSETTE.
9
.
Check that the thickest CASSETTE does not bend the SENSORS.
CASSETTE SUPPORT
PURPOSE:
The CASSETTE SUPPORT should be adjusted 0.5 - 0.7 mm below the BELT. If the
CASSETTE SUPPORT is too low it will cause CASSETTE OPENING and CASSETTE
CLOSING problems. If the CASSETTE SUPPORT is too high it will cause CASSETTE
TRANSPORT problems, mainly with small CASSETTES.
1
.
Loosen the 2 MOUNTING SCREWS from the back.
2
.
Move the CASSETTE SUPPORT 0.5 to 0.7 mm below the TRANSPORT BELT. To do
so turn the 2 ADJUSTMENT SCREWS in or out. The 2 ADJUSTMENT SCREWS are
installed since SN 1110 and SN 5030.
KODAK AG, Stuttgart
figure 4-8
4-7
3053-3
12/1998
Advertisement
Table of Contents
