Message Notification To Digital Pagers - NEC UX5000 Manual

Message Notification

Message Notification to Digital Pagers

Compatibility Guidelines:
When using the UX Mail Administrator to enter dial strings, take care not to enter illegal characters
■
(such as dashes). Enter only those characters allowed by the option you are programming.
Voice mail can send Message Notification to a digital pager. The user must call their mailbox to retrieve their
messages. When a Subscriber, Guest, or Message Center Mailbox user receives a new message, Message
Notification can:
Access an outside line.
■
Call the pager service (i.e., dial the pager's number and wait for the pager service to answer).
■
Send a dial string to the pager service which will cause the pager display to show the user's mailbox
■
number – as well as the number of new messages in their mailbox.
To set up Message Notification to a Digital Pager
1. Set up the general programming that affects all Message Notification.
Be sure at least one voice mail port is enabled for Message Notification callouts.
●
- See Customize: Port Options:
✔ By default, port 4 is enabled for callouts.
Enter the access digits the UX5000 should dial to get an outside line when placing a local or long dis-
●
tance Message Notification callout.
- For local numbers, see Customize: Tenant Options:
- For long distance numbers, see Customize: Tenant Options:
✔ The default entry for these options is 9P.
2. Enter the pager's number.
● To enter this number in the UX Mail Administrator:
- For Subscriber Mailboxes, for example, see the Customize: Mailbox Options, Subscriber: [Mes-
● To optionally enter this number from an extension:
- See step 4 below.
✔ By default, there are no pager numbers entered.
● A typical entry is 2039265400PPPP, where:
- 2039265400 is the pager's number.
- PPPP are pauses that give the pager service time to answer. (See the chart below and add or subtract
202 ◆ Chapter 2: Features
.
C ( 481)
ALLOUT PAGE
■ A typical entry for either option is 9P, where:
- 9 is the trunk access code.
- P is a pause.
sage Notification] options on page 425.
pauses as required.)
Message Notification Pause Durations
Entry
P
PP
PPP
PPPP
PPPPP
PPPPPP
A N C
LLOW OTIFICATION ALLOUTS
[A
CCESS
.
( 456)
PAGE
D ] B L C
IGITS EFORE OCAL ALLOUT
[A D ] B L
CCESS IGITS EFORE ONG
Pause Interval
Do not use
500 mS
1 second
4 seconds
6 seconds
8 seconds
UX Mail Manual
.
( 480)
PAGE
D
ISTANCE