NEC UX5000 Manual page 259

6.2
6.3
6.4
6.5
Step 7
Set up Scheduled Network Delivery (i.e., the time during which the local system can place
network calls to the remote system to deliver messages).
7.1
7.2
7.3
7.4
Step 8 Set how often the system should check the network mailbox to see if there are any new
messages that must be delivered.
8.1
UX Mail Manual
- An internal number could be, for example, the extension number of an OPX circuit
or tie line connected to the remote system.
- This number is not preceded by an access code.
✔ By default, this option is Internal .
C : M O E
USTOMIZE AILBOX PTIONS DIT
- If the remote system is located in another country, enter the International Dialing Prefix (e.g.,
011). If the remote system is installed in North America, this entry should be None ( N ).
✔ By default, this entry is None ( N ).
C : M O E
USTOMIZE AILBOX PTIONS DIT
- If the remote system is located in another country, enter the Country Code for that location
(e.g., 353 for Ireland). If the remote system is installed in North America, this entry should
be None ( N ).
✔ By default, this entry is None ( N ).
C : M O E
USTOMIZE AILBOX PTIONS DIT
- Enter the area code for the remote system. For example, if the remote system is located at
203-926-5400, enter 203 for this option.
✔ By default, this entry is None ( N ).
C : M O E
USTOMIZE AILBOX PTIONS DIT
- Enter the number for the remote system. For example, if the remote system is located at
203-926-5400, enter 9265400 for this option.
✔ By default, this entry is None ( N ).
C : M O E
USTOMIZE AILBOX PTIONS DIT
- Enter the network callout start time ( 0-23 , corresponding to 12:00 midnight to 11:00PM).
- Network messages cannot be delivered to the remote system prior to this time. They
will be queued for a valid delivery time instead.
✔ By default, this option is 8 (8:00AM)
C : M O E
USTOMIZE AILBOX PTIONS DIT
- Enter the network callout end time ( 0-23 , corresponding to 12:00 midnight to 11:00PM).
- Network messages cannot be delivered to the remote after this time. They will be
queued for a valid delivery time instead.
- By default, this option is 17 (5:00PM).
C : C O : [O
USTOMIZE ALLOUT PTIONS
- If the delivery (callout) can't go through (i.e., if the remote site is busy or doesn't answer),
set how long the system should wait before retrying the callout ( 1-999 minutes).
✔ By default, this option is 2 (2 minutes).
C : C O : [O
USTOMIZE ALLOUT PTIONS
- If the delivery (callout) can't go through (i.e., if the remote site is busy or doesn't answer),
specify the total number times the system should attempt to deliver the message.
- After the number of times set in this option, the delivery is aborted and the message is
returned to the sender as a failed message.
✔ By default, this option is 2 (the system will place the original callout and retry once).
C : M O E
USTOMIZE AILBOX PTIONS DIT
- If you need "real time" delivery of new messages, for example, set this option at 1 (one
minute).
- If delivery of new messages once an hour is adequate, set this option for 60 (60 minutes.
✔ By default, this option is 30 (30 minutes).
: [N ] N P N
ETWORK ETWORK REFIX
: [N ] N C
ETWORK ETWORK OUNTRY
: [N ] N A C
ETWORK ETWORK REA ODE
: [N ] N P N
ETWORK ETWORK HONE
: [N ] D B T
ETWORK ELIVERY EGIN IME
: [N ] D E T
ETWORK ELIVERY ND IME
] W N
PTIONAL AIT BETWEEN ETWORK
] N N C
PTIONAL UMBER OF ETWORK
: [N ] W B D
ETWORK AIT ETWEEN ELIVERIES
Chapter 2: Features ◆ 241
Networking (AMIS)
( 415).
UMBER PAGE
C ( 415).
ODE PAGE
( 415).
PAGE
( 416).
UMBER PAGE
( 416).
PAGE
( 416).
PAGE
C ( 330).
ALLOUTS PAGE
A ( 330).
ALLOUT TTEMPTS PAGE
( 416).
PAGE
2