[Message Notification] Notification Phone Number - NEC UX5000 Manual

[Message Notification]
Entering Message Notification numbers in this option does not enable Message
Notification for the mailbox. The Guest Mailbox user must log onto their mailbox and use
Compatibility Guidelines:
■ The default entry for this option is None
■ The following special characters can be entered in the notification number for readability.
( (left parenthesis)
) (right parenthesis)
- (dash)
/ (forward slash)
space
: (colon)
; (semi-colon)
. (period)
, (comma)
\ (back slash)
= (equal)
_ (underscore)
Use this option to enter the Message Notification callout numbers from the UX Mail Administrator, rather than
having the Guest Mailbox user enter the numbers from their extension. The callout numbers you enter in this
option override the mailbox user entries and visa versa. Keep the following in mind when entering numbers:
Internal (extension numbers) are 3 or 4 digits long, depending on UX5000 programming.
●
● Local numbers are 5-8 digits long.
● Long distance numbers are longer than 8 digits.
● You can enter up to 3 callout numbers (corresponding to Indexes 1-3). The number that is active for
notification depends on how the mailbox user has activated Message Notification using the OP + N
options.
● For unique applications, you can override the Call Type option for the number you enter. Refer to Call
Type below for more.
● Normally, trunk access digits for callouts are entered in the following options. If you prefer, the call-
out numbers can contain the access digits and the following options can be left blank.
-
C
USTOMIZE
-
C
USTOMIZE
If entering a digital pager number, append the number with several pauses (P). The pauses give the
●
pager service time to answer.
See
●
M
Options
Digits (30 maximum, using 0-9, # and *)
●
N (None)
●
A (Analyzed pause)
●
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
● P (Pause)
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
UX Mail Manual
Mailbox Options: Guest: [Message Notification]
Notification Phone Number
the OP + N options to activate Message Notification.
: T O :[A
ENANT PTIONS CCESS
: T O :[A
ENANT PTIONS CCESS
N ( 199)
ESSAGE OTIFICATION PAGE
D ] B L C
IGITS EFORE OCAL ALLOUT
D ] B L D
IGITS EFORE ONG ISTANCE
for more.
[T ] F T (
IMERS LASH IMER PAGE
Chapter 3: Programming ◆ 375
Customize
.
( 480)
PAGE
.
C ( 481)
ALLOUT PAGE
.
474)
3