Power On From Network Serial Port; Power On From Remote Console; Operation After Power On - NEC Express5800 Series User Manual

Chapter 3 Setup
1.2

Power ON from Network Serial Port

Depending on the BIOS setting of the CPU blade, the power of the CPU blade may be automatically turned on
by a proper packet received from the network or via the modem connected to the serial port.
This power-on procedure can be specified by setting Wake On Events of System Hardware in the BIOS
SETUP Utility.
1.3

Power ON from Remote Console

The power of the CPU blade can be turned on by using remote control feature of EXPRESSSCOPE Engine 3
(BMC).
1.4

Operation after Power ON

If the CPU blade is connected with a display unit, the NEC logo appears on the screen of the display unit after
a while from the power-on.
Important
While the NEC logo appears, the CPU blade runs the self-diagnosis program (POST) to diagnose the
CPU blade itself. Refer to Chapter 3 (1.5 POST).
Do not power off the server until NEC logo and some message appears.
Express5800/B120d, B110d User's Guide
1. Power-on of Blade Server
85