[Dial Strings] Transfer Internal; [Dial Strings] Transfer External - NEC UX5000 Manual

● W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
● $ - Not used.
Default
✔ None
Transfer Internal
[Dial Strings]
Use this option to set the dial string voice mail uses to transfer an outside call. Voice mail will dial this string
when the Automated Attendant initiates either a screened (TRF) or unscreened (UTRF) transfer.
● See
A
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
M (Monitored pause)
●
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
P (Pause)
●
This command waits for 2 seconds and then continues.
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
● W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
● $ - Not used.
Default
✔ F
Transfer External
[Dial Strings]
Use this option to set up the dial string voice mail uses when routing an External Extension transfer. This
string is typically a flash (F) followed by a trunk access string (such as P9).
● See
E
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
M (Monitored pause)
●
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
P (Pause)
●
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.)
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
UX Mail Manual
This dial string is automatically set during installation. You
should not change this entry from its default setting.
A ( 68)
UTOMATED TTENDANT PAGE
for more.
E ( 137)
XTERNAL XTENSION PAGE
System Options: [Dial Strings]
for more.
[T ] F T (
IMERS LASH IMER PAGE
[T ] F T (
IMERS LASH IMER PAGE
Chapter 3: Programming ◆ 467
Customize
.
474)
.
474)
3