Honeywell Gent Viglion EN54 Generic Commissioning Instructions page 13

Indicators and controls
Display
Zones 1
(red)
Power
(green)
Fire
(red)
Verify
(amber)
Fault
(amber)
System Fault
(amber)
Disablement
(amber)
Warning
(amber)
CB253 or CB254
(amber)
Power Fault
(amber)
Sounder
(amber)
Delay
(amber)
Test
(amber)
Commission
(amber)
Menu On/Off
to
F1 F4
Cancel Buzzer
Next
Sound Alarms
Silence Alarms
Reset
4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
Description
The 'display' provides messages of the system status and events. Most panel display have
8 lines by 40 characters per line display.
Hidden-until-lit fire zone indicators. When "Zones" text and number(s) are illuminated it
indicates that a FIRE has been detected in the specified zone(s).
When illuminated it indicates that a supply to the panel is present.
When illuminated it indicates that a FIRE has been detected in the protected premises.
When illuminated it indicates that the Verify button has been pressed and the alarm
sounders in the system are delayed from sounding.
When illuminated it indicates that a FAULT has been detected in the fire detection and
alarm system or in the audio system.
When illuminated it indicates that a fault has occurred with the system processor. It is
important to investigate this fault because the fire alarm system may not be able to
detect fires.
Applicable for EN Vigilon panels only
When illuminated it indicates that a part of the system has been disabled.
Applicable for BS Vigilon panels only
When illuminated it indicates that a part of the system has been disabled, delayed or not
functioning.
When illuminated it indicates command builds 253 or 254 has been activated.
When illuminated it indicates the battery or mains supply to the panel has failed.
EN Vigilon panels only
When illuminated (always with either the FAULT light or the DISABLEMENT light) it
indicates that there is a sounder fault (flashing indication) or sounder disablement (steady
indication).
EN Vigilon panels only
When illuminated it indicates that one or more delay blocks are setup on the panel.
EN Vigilon panels only
When illuminated it indicates one or more zones are in Test mode.
EN Vigilon panels only
When illuminated it indicates panel is in commissioning mode.
Pressing Menu On/Off enables/disables the on screen menu facility which gives access to
the system menus.
The 'Fn' buttons are used to select functions and sub-functions of the system menus which
appear on the display. Each option in the menus, corresponds to one of the function
buttons and pressing a button will select the option which appears above it on the display.
The Cancel Buzzer button when pressed will stop the internal panel buzzer from
sounding.
Note the local buzzer is automatically silenced when the emergency microphone is being
used to announce live speech, on Vigilon Compact VA panel.
Pressing the Sound Alarms button will announce evacuate message and sound evacuate
alarms. This button is only pressed in an emergency or at other agreed times, for example
when conducting a system test or practice evacuation.
Pressing the Silence Alarms button will stop emergency message announcements and
silence the system alarms.
Pressing the Reset button will clear any fires and return the panel to its normal state. If a
fire condition occurs immediately after reset then the indicated device should be
investigated.
Vigilon (EN & BS) Compact (VA) panels
13