Table of Contents
Advertisement
Generic Commissioning instructions
Network Card baud and node address Switches
&
The copper network card is factory set for 38.4K baud with node address 4.
Component side
1 2 3 4 5
6 7 8
On
Off
Powering-up the Network
¨
Add one panel at a time starting from the network controller (Node 1) at side 1.
"
It can take a few minutes for the system map to update.
¨
For each panel powered-up the network controller will automatically try to establish communication with the
connected equipment.
¨
The network controller will display the status of the network as being started, secure or non-secure and from now on
will monitor and control the network communications.
¨
Use disable comms to isolate a panel from the rest of the network, ie it operates at the network card in an echo
mode, select Menu On/Off -> [Control] -> [Disable] -> [Comms] and enter the Network Card number 4.
How to check a Network map
¨
Using the Menu On/Off -> [Info] -> [Map] -> [NetMap] menu, enter the network card address, usually 4.
The display will provide a list in cabling order the addresses of panels in the networked system.
These are examples of different networks. The lowest address '1' has been given to the network controller.
Map information for Network at card 10
Nodes on side 1
1
9
7
6
5
Nodes on side 2
1
3
Map information for Network at card 10
Nodes on side 1
1
9
7
6
5
Nodes on side 2
1
3
5
6
7
68
Node address
8
7
6
64 off off off off off off off off 2400
1
on off off off off off on off 9600
2
off on off off off off off on 19.2K
3
on on off off off off on on 38.4K
4
off off on off off off
63 on on on on on on
- factory settings
3
1
9
1
Baud rate
5
4
3
2
1
Address
Baud
4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
This example shows the network is not
secure
This example shows the network is
secure
Advertisement
Table of Contents
