Table of Contents
Advertisement
Data and Installation instructions
Main Control Cards
(EN version 4.xx panels or nodes)
This leaflet covers a range of Main Control(ler) Card
(MCC) options for EN version 4.xx control panels
and Network nodes. Each MCC is supplied with a
number of chips having part numbers 2211-xxx,
see chart overleaf. The appropriate chip must be
fitted to the card before card installation. Card
options:
¨
VIG-MCC-UPGR
¨
VIG-MCC-EN-NOD-UPG.
P4 to accept a
40-way ribbon
cable from the DKC
Reset
Switch
SW1
Part number
2211-xxx
BATT1
MCC card socket fits
into the Backplane slot for (LCC)
Lithium battery + side up
Remove sleeve before
installing the card
Chip 2211-xxx
¨
Fit the correct chip 2211-xxx in the MCC for the
type of panel or node, see chart overleaf.
Battery connection
The MCC has a battery sleeve that must be
removed before the card is fitted in the backplane.
&
Once the battery sleeve is removed from
the MCC, the card MUST NOT be placed on a metal
surface as this may result in damage to the
components on the card.
4188-861 issue 1_01/06_MCC EN
P2 for future use
USB port for
future use
Backplane
The MCC card must be installed in the correct
location in the backplane.
P1
To DKC
P4
LCC - P1
IOC- P2
LOOP 1 - P3
LOOP 2 - P4
LOOP 3 - P5
LOOP 4 - P6
P7
P8
Vigilon Control panel and
Network node backplane
# A RAM Card is only fitted in Vigilon panel
having 16 line display and where the
backplane has no flash.
Technical data
Overall size
157mm height x 100mm
width
Weight
96g (approximate)
Lithium Battery
CR2032 3V cell.
Replace the battery only
with the same or equivalent
type. Dispose of all used
batteries according to the
manufacturer's instructions.
Operating
0°C to 45°C
temperature
Storage temperature -10°C to 55°C
Relative humidity
up to 90%
(non condensing)
by Honeywell
40 way ribbon
cable
20 way ribbon
cable
Main Control card
Input/Output card
Loop Processor card
Space for 3 Loop
Processors
RAM Card #
Network card
1
Advertisement
Table of Contents
