Table of Contents
Advertisement
Generic Commissioning instructions
Appendix C - Guidelines for standalone system
commands
This appendix provides guidance on factors that must be taken into consideration when applying standalone system functions, such
as:
¨
labels
¨
sectors (including flag set sectors)
¨
delay blocks
¨
time slots and time blocks
¨
zones
¨
groups
¨
voice alarm zones
¨
command builds
¨
sounder configuration
¨
auxiliary relays
Labels
¨
Labels are given to identify location of areas on a site.
¨
A previously created label can be modified.
"
Where manual call points are being used then each can only have a label of up to 28 characters.
¨
a 32 character label can be assigned to a:
•
device
(must have a label having 28 characters if it is an MCP)
•
each Input/Output line
(must have a label having 28 characters maximum if one or more MCPs are installed on the input line)
•
zone
•
group
•
control panel
Input channel label
¨
A supervisory input channel label of an interface unit will only be displayed at the control panel of the standalone
system.
•
By adding an * in front of the channel label it will allow the label to appear on all the networked panels.
The networked panels must however be setup to display all events. In this configuration the label will also be
displayed at a network node and GENT Supervisor in the network.
•
When an interface input is operated the standalone system's (local) control panel buzzer can only be activated
by configuring the input to trigger a command build. In this case the command build should not have actions.
•
To activate buzzers of control panels in a network an * must be inserted before the command build label.
114
4188-856_i2_12/06_Generic Vigilon (Compact + VA) Comms.
Advertisement
Table of Contents
