Influencing Simulation - Siemens SINUMERIK 810M Operating And Programming Manual

09.91

3 . 1.14.2 Influencing simulation

The simulation can be influenced so that it is adapted to the program sequence in the
"AUTOMATIC" mode.
Sequence of operation
PART
PROGRAM EDIT
1 6
% F K
SELECT SIMULA-
PROGRAM TION
The new softkey menu shows four possible selections:
PROGRAM
BLOCK DISPLAY
CONTROL
SEARCH TYPE
a) b)
c)
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
Operate the "PART PROGRAM" and "EDIT" softkey,
one after the other in any of the operating modes:
PRESET / JOG / AUTOMATIC /
INC FEED 1 .... INC FEED 10000 / REFPOINT.
Using the numerical keyboard, enter the desired
program number "% ..." (or "L..."), "% 16" in the
example.
Operate the "SELECT PROGRAM" and "SIMULATION"
softkeys one after the other.
Using the ETC key, extend the displayed softkey menu.
These four possible selections are
SIMUL.-
described in more detail in the following
DATA
paragraphs a) to d).
d)
6ZB5 410-0EQ02
3 Operating Sequences
3.1.14 "SIMULATION"
3-75