Incremental" Mode ("Inc Feed 1 - Siemens SINUMERIK 810M Operating And Programming Manual

3 Operating Sequences
3.2.8 "Incremental´ " mode ("INC FEED 1 ... INC FEED 10000")
3.2.8 "Incremental" mode ("INC FEED 1 ... INC FEED 10000")
In this mode, operation is NC-controlled in "JOG/manual" mode, not in a program; with each
operation of the direction key, you traverse the axis concerned in the selected direction by the
set increment.
The increment values are settable as follows:
1, 10, 100, 1000, 10000 increments. The weighting of the increments depends on the display
resolution. However, the smallest possible traversing distance is defined by the input
resolution.
The feedrate and the display resolution are defined in
Sequence of operation
INC ...
100
10
1
3-126
the machine data.
Operate the operating mode selection
key on the integrated machine control
panel and then any of the "INC 1" to
INC 10000" softkeys or...
1 000
10 000
... set the operating mode selector switch,
on the external machine control panel, to
the setting "1", "10", "100", "1000"
or "10000"("1" in the example) .
© Siemens AG 1990 All Rights Reserved
01.93
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)