Siemens SINUMERIK 810M Operating And Programming Manual page 181

01.93
Data type
MPF Part program (Main Program File)
SPF Subroutine (Sub Program File)
TOA Tool offset (Tool Offset Active)
ZOA Zero offset (Zero Offset Active)
TEA 1 NC machine data (TEsting Data Active 1)
TEA 2 PLC machine data (TEsting Data Active 2)
PCA PLC alarm text (Programmable Control Alarms)
PCP PLC program (Programmable Control Program)
RPA R parameters with assigned values (R Parameter Active)
SEA Addresses with assigned values (SEtting Data Active)
CLF Clear instruction (CLear File)
UMS User Memory Submodule
Under Interface Assignment: the control indicates the identifier of the connected
device type for Interface 1 and Interface 2. (For identification of various device types see
Section 6.3).
STOP
Using the "STOP" softkey, you can interrupt data input at any time.
DATA IN
START
You continue data input again.
During data input it is not possible for the control
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
Meaning
to call up specific data!
6ZB5 410-0EQ02
3 Operating Sequences
3.1.15 Data input/data output
3-83