Siemens SINUMERIK 810M Operating And Programming Manual page 239

3 Operating Sequences
3.2.12 "Repositioning" mode ("REPOS")
Sequence of operation
Preconditions:
You have generated a program interruption - e.g. by switching to "JOG" mode - and sub-
sequently traverse away from the contour (see Section 3.2.7 for sequence of operation).
REPOS
and
or
((Bild 810M/9 einmontieren))
+X +Z
–4
– Y +Y
– Z – X –4
3-136
Operate the operating mode selection key on the
integrated machine control panel and then the
"REPOS" softkey or ...
... set the operating mode selector switch on the
external machine control panel to this symbol.
This display appears on the CRT.
The red "Feed hold" LED display extinguishes.
Using the direction keys, you traverse to the point
of interruption.
Note:
A maximum of 2 axes can be traversed at anyone
time!
The feedrate override switch is active, the rapid
override key is not active!
© Siemens AG 1990 All Rights Reserved
09.91
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)