Simulation; Simulation "Area Of The Workpiece - Siemens SINUMERIK 810M Operating And Programming Manual

11.90
3.1.14

"SIMULATION"

With the "SIMULATION" function, it is possible to test a program. The traversing movements
of the tools are simulated graphically on the CRT.

3.1.14.1 Simulation "AREA OF THE WORKPIECE"

• A graphic display with input fields simplifies the input of the values for the simulation area
and the dimensions of the workpiece.
• Select the simulation area so that the programmed traversing range is covered.
• The values entered need not be in proportion to the display; the simulation area is not cut
off, because the control evaluates the larger value for the display.
The NC channels and the simulation channel can
influence each other because they use common data.
Common data are, for example:
– Settable zero offsets
– Programmable zero offsets
– Tool offset
– Global R parameters
– Machine data
– Setting data.
Any influencing of the data in the NC channels by the simulation channel
can be prevented by an interlock. Simulation simultaneously with
Sequence of operation
PART
PROGRAM EDIT
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
processing then is not possible!
In any of the operating modes:
PRESET / JOG / AUTOMATIC /
INC 1 .... INC 10000 / REFPOINT,
operate the "PART PROGRAM" and "EDIT" softkeys one
after the other.
6ZB5 410-0EQ02
3 Operating Sequences
3.1.14 "SIMULATION"
3-71