Siemens SINUMERIK 810M Operating And Programming Manual page 206

3 Operating Sequences
3.2.3 Influencing "AUTOMATIC" operation
Sequence of operation
REPOS
and
or
The "REPOS offset" with reference to the endpoint of the preceding block appears on the
display.
+X +Z
– 4
– Y +Y
+4
– Z – X
AUTO-
MATIC
or
Program processing continues after you have pressed the "NC start" key.
3-106
Operate the operating mode selection key on the
integrated machine control panel, and then the
"REPOS" softkey or...
... set the operating mode selector switch on
the external machine control panel to this
symbol.
Operate the relevant direction keys.
The control guides the tool using linear
interpolation to the endpoint of the preceding
block.
Now switch again to "AUTOMATIC" mode
using the softkey or the mode selection
switch.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
09.91
6ZB5 410-0EQ02